Nylon cable splicing mold is a good helper for making molds. The temperature requirements of this kind of mold equipment are also some of the following.

1 Nylon cable ties are hygroscopic. Do not open the package before use. After opening the package in a wet environment, try to use up within 12 hours, or repack the unused nylon cable ties so as not to affect the nylon ties during handling. The tensile strength and rigidity of the belt.

2 manipulation

When using, use the tension to pull the tensile strength (tension) of the nylon cable tie itself. 3 The diameter of the bundled object is smaller than the diameter of the nylon cable ties. The remaining length of the belt is preferably 80mm. Nylon cable ties maintain excellent mechanical properties over a wide temperature range (-40 to 120 ° C)

Characteristics and resistance to heat aging Humidity affects nylon cable ties. Nylon cable ties maintain excellent mechanical properties in a humid environment. Nylon sheets are hygroscopic, humidity (water content) increases, and have higher elongation and impact strength. However, the tensile strength and rigidity are gradually reduced.

Electrical characteristics and flame retardancy Nylon cable ties have a good edge, electrical rated temperature less than 105 degrees does not affect its performance, flame retardancy reached UL measurement 94V-2. The plastics industry is worthy of vigorous development, and the prospects are very optimistic. It is understood that the high growth of the plastics industry is not diminished.

In a high-speed development period. Electronic communications, automobiles, building materials, office equipment, and daily necessities are still driving the rapid development of plastics. It is expected that the annual average consumption of plastics will increase by 18%. The plastics industry is a sunrise industry worthy of vigorous development, and it is also a market prospect.

Good industry. Therefore, it is necessary to establish an e-commerce platform with a system of admission to regulate the quality of market products, which in turn drives the upgrading and transformation of the entire plastics industry. Access is the standard, which is the threshold for entering the market. It is to combine the direct and indirect experience of plastic processing companies,

Establish its own standard system and form a technical support platform for upgrading plastic products.